黄石工矿集团胡家湾矿井初步设计

文档编号:CKZS016   文档字数:40018,页数:110   附CAD，外文翻译

摘  要
本设计的井田面积为3.9平方千米，年产量45万吨。井田内煤层赋存比较稳定，煤层倾角28，平均煤厚3.2m，整体地质条件比较简单，在井田范围东部和中央均有断层发育。沼气和二氧化碳含量相对不高，涌水量也不大。根据实际的地质资料情况进行井田开拓和准备方式的初步设计，该矿井决定采用立井家暗斜井二水平开采，设计采用爆破采煤一次采全高回采工艺，走向长壁采煤法，用全部跨落法处理采空区。并对矿井运输、矿井提升、矿井排水和矿井通风等各个生产系统的设备选型计算，以及对矿井安全技术措施和环境保护提出要求，完成整个矿井的初步设计。矿井全部实现机械化，采用先进技术和借鉴已实现高产高效现代化矿井的经验，实现一矿一面高产高效矿井从而达到良好的经济效益和社会效益。
关键词：立井、倾斜长壁、一次采全高、爆破采煤、高产高效

Abstract
 
 This design well field area is 3.9 square kilometers, the annualoutput 450,000 tons. In the well field the coal bed tax saves quitestably, the coal bed inclination angle 28, average coal thick 3.2m,the overall geological condition quite is simple, and central has thefault growth east the well field scope. The methane and the dioxide carbon content relative are not high,wells up the water volume not to be big. Carries on the well fielddevelopment and the standby mode preliminary design according to theactual geological data situation, this mine pit decided uses verticalshaft inside slope two levels mining, the design uses the demolitionto mine coal time picks entire Gao Huicai the craft, moves towards thelong wall mining coal method, with all cross falls law processing topick the depletion region. And to the mine pit transportation, the mine hoist, the mine pitdrains water and ventilates and so on each production system theequipment shaping computation, as well as sets the request to the minepit security technology measure and the environmental protection,completes the entire mine pit the preliminary design. The mine pitcompletely realizes the mechanization, uses the advanced technologyand the model has realized the high production highly effectivemodernization mine pit experience, realizes an ore high productionhighly effective mine pit thus to achieve the good economic efficiencyand the social efficiency at the same time.
Key word: vertical shaft, incline long wall, full-seam mining,demolition mining coal, high yield highly active

目  录
前  言 1
1  矿区概况及井田地质特征 2
1.1矿区概况 2
1.2井田地质特征 5
1.3煤层及煤质 7
1.4水文地质特征 8
1.5煤炭产品的供求现状 11
2  矿井储量、年产量及服务年限 13
2.1井田境界 13
2.2井田储量 13
2.3矿井年储量及服务年限 18
3  井田开拓 19
3.1概述 19
3.2井田开拓 19
3.3井筒特征 25
3.4井底车场 28
3.5开采顺序及采区回采工作面的配置 40
3.6井巷工程量和建井周期 42
4  采煤方法 45
4.1采煤方法的选择 45
4.2采区巷道布置及生产系统 45
4.3回采工艺设计 52
5  矿井运输、提升及排水 56
5.1矿井运输 56
5.2矿井提升 63
5.3矿井排水 73
6  矿井通风与安全技术措施 84
6.1矿井通风系统的选择 84
6.2风量机算及风量分配 86
6.3全矿通风阻力计算 91
6.4扇风机选型 95
6.5矿井安全技术措施 98
7  矿山环保 101
7.1矿山污染源概述 101
7.2矿山污染源的防治 102
7.3地表塌陷及生态保护措施 104
结  论 105
致  谢 106
参考文献 107

相关论文