网站地图| 免费获取|
毕业论文网
  • 网站首页|
  • 论文范文|
  • 论文降重|
  • 职称论文发表|
  • 合作期刊|
  • 论文下载|
  • 计算机论文|
  • 外文翻译|
  • 免费论文|
  • 论文资料|
  • 论文开题报告
搜索

当前位置:毕业论文网 -> 论文范文 -> 测控技术 -> 基于AD590的火灾报警系统的设计
自动化论文范文| 电子机电论文| 测控技术论文| 通信专业论文| 电气工程论文| 通信工程论文| 电子信息工程论文| 免费自动化论文| 免费电子论文| 免费电气论文| 免费通信论文

基于AD590的火灾报警系统的设计

本文ID:LW16796 字数:9640,页数:24 价格:¥118.00 → 信用说明

扫一扫 扫一扫
基于AD590的火灾报警系统的设计

文档编号:CK049   文档字数:9640,页数:24

摘  要
 随着经济的不断发展,城市规模的不断扩大,工业与民用建筑日趋增多,为了有效保护人民的财产和生产的安全,火灾自动报警监控系统已成为现代楼宇设计中不可缺少的部分。
 火灾的发生都将伴随着烟雾、热量和火焰的产生,因此烟、热、光是检测火灾的重要依据。本次毕业设计考虑从热量(温度)的角度来设计简易的火灾报警系统,整个系统以温度传感器AD590采集现场温度,输出的电信号经ADC0809转换后送入单片机,以实现报警监控的功能。当采集到的温度大于设定的报警极限值,则蜂鸣器报警,同时系统状态指示灯显示异常状态。经检验,本次的设计能在实际环境中正常运行,实现预期的功能。

关键词:温度传感器  AD转换器  单片机  火灾  报警

Abstract
 With the continuous economic development and the expanding size of cities,the industry and the civil architecture increase day by day,in order to effectively protect people’s property and production safety,fire autoalarm supervisory control system has become an integral part of the modern building .
 Smoke, heat and flame always appear when fire happens ,so the smoke , heat and light are the  important basis of fire detection.This graduation practice,it is a simple fire autoalarm control system which is based on heat (temperature) only.The whole system uses temperature sensors AD590 to collect the scene temperature ,and sends the electric output signal to the single chip microcomputer  to realize the function of warning .When the temperature is higher than the limit temperature, the buzzer alarms, and system status indicator shows abnormal state.Upon examination, this design can function properly in the real environment and can achieve the desired functionality.
 
Keywords:Temperature Sensors  AD converter  Single Chip Microcomputer  Fire  Alarm

目录
摘  要 I
Abstract II
1  前 言 1
1.1 研究课题的意义 1
1.2 国内外研究现状 1
1.3 毕业设计的设计要求 2
2  总体方案设计 3
2.1  系统总体结构 3
2.1  系统硬件结构 4
3 基于AD590的温度采集电路设计 5
3.1  温度传感器的选择 5
3.1.1 感温火灾探测器的概述及安装要求 5
3.1.2 设计方案的构思 6
3.1.3 温度传感器概述 6
3.1.4 设计方案的选择 6
3.1.5 AD590的基本介绍 7
3.2 基于AD590的温度采集模块的设计 7
3.2.1 AD590的输出电路设计 7
3.2.2 绝对/摄氏温标转换电路 8
图2-4 绝对/摄氏温标转换电路 9
4 基于ADC08009的模数转换模块的设计 10
4.1  ADC0809的时钟频率的设计 10
4.2 四分频电路的设计 10
4.2.1  D触发器的工作原理 10
4.2.2 四分频电路的组成 11
4.3 ADC0809与AT89C52的连接电路 11
4.3.1 AD转换器的接口技术 11
4.3.2 ADC0809芯片介绍 12
4.3.3 ADC0809与AT89C52的连接设计 13
5 报警显示电路 14
5.1 蜂鸣器电路的设计 14
5.2  显示电路的设计 14
5.3 系统复位电路的设计 15
7 致谢 17
8 参考文献 18
9 附 录 19

基于AD590的火灾报警系统的设计由毕业论文网(www.huoyuandh.com)会员上传。
原创论文资料流程 相关论文
上一篇:智能门锁系统 下一篇:智能照明节电器的设计
推荐论文 本专业最新论文
Tags:基于 AD590 火灾 报警系统 设计 2011-04-01 16:15:50【返回顶部】
发表论文

联系方式 | 论文说明 | 网站地图 | 免费获取 | 钻石会员 | 硕士论文资料


毕业论文网提供论文范文,论文代发,原创论文资料

本站部分文章来自网友投稿上传,如发现侵犯了您的版权,请联系指出,本站及时确认并删除  E-mail: 17304545@qq.com

Copyright@ 2009-2020 毕业论文网 版权所有