基于单片机的多点温度检测系统

文档编号:JD159  字数:10996,页数:48

摘要

DS18B20是一种可组网的高精度数字式温度传感器，由于其具有单总线的独特优点，可以使用户轻松地组建起传感器网络，并可使多点温度测量电路变得简单、可靠。本文结合实际使用经验，介绍了DS18B20数字温度传感器在单片机下的硬件连接及软件编程，并给出了软件流程图。
该系统由上位机和下位机两大部分组成。下位机实现温度的检测并提供标准RS232通信接口，芯片使用了ATMEL公司的AT89C51单片机和DALLAS公司的DS18B20数字温度传感器。上位机部分使用了通用PC。该系统可应用于仓库测温、楼宇空调控制和生产过程监控等领域。
关键字：温度测量；单总线；数字温度传感器；单片机

Abstract
    As a kind of high-accuracy digital net temperature sensor，DS18 B20 can be used building a sensor net easily. It can also make the net simple and reliable with it's special 1-wire interface .This paper introduces the application of DS18B20 with single chip processor.
The system is constituted by two parts the temperature measured part and displayed part. The temperature measured part has a RS232 interface. It used AT89C51 of ATMEL company and DS18B20 of DALLAS company .The displayed part uses PC .This system is applied in such domains as warehouse detecting temperature；air-conditioner controlling system in building and supervisory productive process etc.

Key words：temperature measure；single bus；digital thermometer；single chip processor；

目  录

摘要........................................................................... 2
Abstract .......................................................................3
第一章 绪论 ...................................................................4
1.1系统背景.................................................................... 4
1.2 系统概述 ...................................................................4
第二章 方案论证.................................................................5
2.1 传感器部分..................................................................5
2.2主控制部分 ..................................................................6
2.3  系统方案...................................................................6
第三章硬件电路设计.............................................................7
3.1 电源以及看门狗电路 .........................................................8

3.2键盘以及显示电路 ............................................................9
3.2温度测试电路 ................................................................11
3.3 串口通讯电路 ...............................................................15
3.4 整体电路................................................................... 16
第四章 软件设计 ................................................................16
4.1 概述 .......................................................................16
4.2 主程序方案................................................................. 16
4.3 各模块子程序设计 ...........................................................18
第五章 系统调试.................................................................20
5.1 分步调试 ...................................................................20
5.2 统一调试................................................................... 20
结束语................................................................... ......21
参考文献 .......................................................................22
附录一:软件流程图 ..............................................................24
附录二：电路原理图 .............................................................25
致  谢......................................................................... 27
源程序......................................................................... 28

相关论文