|
文档编号:HG096 文档字数:13397,页数:35 摘 要：本文研究了流量对反应床层特性的影响，获得了流化床厌氧反应器生产负荷变化规律，流量对反应床层膨胀率、各组分产气量、产生气体中各组分含量、反应器内污泥颗粒大小的影响和气体产生对床层膨胀率的影响；并对中试规模的关键设备进行了选型及设计计算，同时规划了工艺流程。研究结果显示：床层实际初始流化流量vmf在3.73～4.16mL·min-1之间，与理论计算值3.864mL·min-1一致；在一定范围内，流量增大对反应量的提高是有利的，当流量为11.2mL·min-1时，单位时间内的反应量达到最大，反应负荷为4.66mg·L-1·min-1；适当提高流量有利于提高各组分的产气量，但流量对气体相对含量的影响不显著，甲烷含量约是二氧化碳含量的7倍；由于气体产生，热模时床层膨胀率明显高于冷模，在实验范围内，随流量的增大，膨胀率相差有越来越大的趋势；适当提高流量有助于污泥颗粒的成长。
Abstract：In this paper, the influence of flow on the bed characteristics is researched, variation of the production load of the fluidized bed anaerobic reactor, the influence of the flow on the bed expansion rate, gas production of each component, the relative content of the gas produced, the size of granular sludge and the influence of the gas produced on the bed expansion rate are obtained. The key pilot scale equipments are selected on the basis of calculation and the process flow is designed. Research shows that: actual minimum fluidization flow, 3.73～4.16mL·min-1, is in good consistency with minimum fluidization flow, 3.864mL·min-1, in theory. Within a certain range of the flow, large flow is help to production load. When the flow is 11.2mL·min-1, the maximum production load is 4.66mg·L-1·min-1. Improving the flow properly is help to gas production of each component, but influence of flow on the relative content of the gas produced is not significant, the content of CH4 is almost 7 times than CO2. The bed expansion rate in cold model test is obviously higher than it in hot model test due to the gas produced. Within a certain range of the experiments, the difference value of bed expansion rate in the tests becomes larger when improving the flow. Improving the flow properly is help to the growth of the granular sludge. 目 录 中文摘要 I
|
|
| |
| 上一篇：小波变换-主成分回归分光光度法同.. | 下一篇：基于混合粒子群算法的微波酯化反.. |
| 推荐论文 | 本专业最新论文 |
| Tags：流化床 反应器 工艺 研究 | 2011-03-30 13:22:19【返回顶部】 |
