电刷镀实验转胎的设计

文档编号:JX549  文档字数:12716,页数:23 有开题报告，任务书，文献综述，外文翻译，设计图

 摘要：本设计中所设计的是供实验室所用的电刷镀转胎，工件的安装方式为卧式。它主要由动力部分、传动部分、机架及电控部分所组成。本机主要是提供给实验室做实验而设计的，因此只要能满足将工件均匀刷镀即可,设计中的有关数据准确度不是要求太高。本次设计，主要进行了支撑轴的设计，转胎机架、锁紧装置以及传动部分的宝塔轮、联轴器等的设计计算。同时论述了本机的检验、维护等事项。
关键词：电刷镀转胎  锁紧装置  宝塔轮  电动机

 Abstract: This design is designed for laboratory use to fetal electro-brush plating, the work piece for horizontal installation. It is mainly by the power of the transmission of the frame and formed part of electronic control. The machine is mainly provided to the laboratory experiments were designed, and therefore will work as long as they can meet the uniform plating can be, the design of the accuracy of the data is not too demanding. The design, the main axis for the support of the design, to tire rack, locking devices, as well as part of the pagoda drive wheels, such as the design coupling calculation. At the same time on the inspection of the aircraft, maintenance and so on.
Keyword: Brush Plating to fetal   Locking device  Baota round  Motor

目  录
1、前言 1
2 主体设计 1
2.1选择电动机 2
2.2.传动方案的选择 4
2.3.减速器的选择 4
2.4、皮带的选择 5
2.5皮带轮的设计 5
2.6.选择支承轴 7
2.7.锁紧装置的设计 8
2.8.选择轴承 9
2.9轴承的润滑方式选择 10
2.10．轴承座的选择 10
2.11.联轴器 10
2.12.转胎底座的设计 12
3 电刷镀的设备及镀液的选择 14
3.1电刷镀的设备 14
3.2表面处理用的溶液 15
3.3刷镀金属层用的溶液 17
4 结  论 19
5 致    谢 20
参考文献 21
英文摘要及关键字 21

相关论文