基于PLC与人机界面的工业伺服自动控制系统

字数:12347,页数:33   文档编号:ZD118

[摘要] PLC是在传统的顺序控制器的基础上引入了微电子技术、计算机技术、自动控制技术和通讯技术而形成的一代新型工业控制装置。随着工业的进步，PLC在工业控制系统的应用上也越来越广泛。本文介绍了一种基于PLC与人机界面的工业伺服自动控制系统的原理和设计过程。该控制系统用PLC将采集到的现场接近开关信号、传感器信号在不同角度范围比较各部分工作条件从而控制各个部分动作或报警输出。本文介绍了三菱FX2n-64MT PLC的特性和工作原理，给出了它与各模块组成的自动控制系统的方法，包括它的硬件设计和软件编程。

[关键词] 可编程控制器   变频器   伺服电机   步进电机

AUTOMATIC CONTROL SYSTEM OF INDUSTRIAL SERVO BASE ON THE PLC AND MAN-MACHINE INTERFACE
 

Abstract  PLC is in the traditional sequence controller on the basis of the introduction of the micro-electronics technology, computer technology, automatic control and communication technologies and the formation of the new generation of industrial control devices. With industrial progress, PLC control system in the industrial application of the increasingly widespread. In this paper, a PLC-based human-machine interfaces and industrial servo control system and the principles of the design process. The control system uses the PLC will be collected at the scene encoder signal, close to switching signals, the sensor signals at different angles for each part of the working conditions so as to control various parts of action or alarm output.   

Key words  PLC   Servo motor   Stepper motor

目 录
摘要 .........................................................................i
Abstract.....................................................................ii
目 录 ......................................................................iii
引 言........................................................................1
第1章  伺服自动控制系统的概述................................................2
1.1 系统工作原理.............................................................2
1.2 系统总体框图.............................................................2
第2章  各部件简单介绍 .......................................................3
2.1 三菱FX2n-64MT PLC .......................................................3
2.2 松下Minas A4系列AC伺服驱动器.............................................4
2.3 士林SS-021变频器.........................................................6
2.4 WZM-2H057MS步进电机 .....................................................9
2.5 WENVIEW510T触摸屏 ......................................................10
2.6 传感器..................................................................10
2.7 亚德客磁性开关 .........................................................11
第3章  系统实现方法 ........................................................12
3.1 动作流程图..............................................................12
3.2 PLC控制程序软元件分配表.................................................13
3.3 接线原理图 .............................................................14
3.4 气动原理图..............................................................14
3.5 PLC编程设计.............................................................15
3.6 触摸屏编程 .............................................................19
3.7 设计注意事项............................................................22
第4章  程序调试 ............................................................24
4.1 调试环境 ...............................................................24
4.2 硬件连接 ...............................................................24
4.3 调试步骤及结果 .........................................................24
结  论 .....................................................................27
致谢语......................................................................28
参考文献....................................................................29

相关论文